Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Some products sold on this website may expose you to chemicals known to the State of
California to cause cancer, birth defects, or other reproductive harm.
All electrical products must be installed by a qualified electrician in accordance
with local wiring regulations. Incorrect installation may result in fire, electric
shock, or injury.
Always disconnect power at the circuit breaker before installation.
💡
Bulb & Usage Advisory
Do not exceed the maximum wattage specified on the fixture label.
Keep away from flammable materials. Allow adequate ventilation around the fixture.
Keep out of reach of children. Not suitable for wet locations unless rated IP65 or higher.
Item Name:USB male plug to led light Band solderless clip cable . Input: USB male connector . Output: 8mm LED light Band solderless clip. Total length: 15 CM/5.9 inch . Wire gauge: 24AWG . JACK polarity:DC plug Inside(Positive) / outer(Negative) ;Clamp Plug Red (Positive)/Black (Negative). Package Content: 6 x USB male plug to led light Band solderless clip cable How to use: 1. Open the white cap of the connector. 2. Put the LED Band on the pins: align the + to the + and the - to the - of the Band lights. The 2 copper spots should be right on the pins ( You can leave longer copper spot when cut the Band). 3. Close the cap with strength. Make the two copper points of the light bar and the clip spring contact more firmly 4. Gently try pull on the LED Band to confirm youve made a solid connection. 5. Finish so easy!
⚠️ WARNING (California Proposition 65): This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
WELCOME5: Use code WELCOME5 for 5% off on your first order
