Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF your first order!
Free Shipping on Most USA Orders
Some products sold on this website may expose you to chemicals known to the State of
California to cause cancer, birth defects, or other reproductive harm.
All electrical products must be installed by a qualified electrician in accordance
with local wiring regulations. Incorrect installation may result in fire, electric
shock, or injury.
Always disconnect power at the circuit breaker before installation.
💡
Bulb & Usage Advisory
Do not exceed the maximum wattage specified on the fixture label.
Keep away from flammable materials. Allow adequate ventilation around the fixture.
Keep out of reach of children. Not suitable for wet locations unless rated IP65 or higher.
Power: 25W Voltage: 110V Wavelength: 185nm and 253.7nm The base timer could be set for 15,30,60 minutes. To set the timer, hold a desired time Delay button until the lamp blinks and the lamp will turn off in the set amount of time. To pair: 1. Power up the by pressing the “On/Off” button 2. Within 5 seconds after the device was powered up, hold “On/Off” button for at least 3 sec to pair the device. If it blinks pairing is successful To unpair: 1. Within 5 seconds after the lamp is powered, press and hold the “Delay 15 min” button for at least 5 seconds 2. After the 5 seconds, the lamp will blink indicating that the unpairing is successful Warning: When using this lamp, don’t look directly at the working bulb. Prolonged exposure to UV rays can burn human and animal skin and damage eyes. Avoid touching the lamp tube; it might reduce the lifespan of the lamp. People/pets/plants can’t be exposed to the UVC light and must leave the room when the lamp works. An ozone generating lamp will produce ozone gas that has a strong irritating smell. Dont enter the room for one hour after you turn off the light and open the windows to ventilate the area. READ SAFETY WARNINGS BEFORE YOU BUY: This unit should not be used for illumination purposes. Exposure to ultraviolet light can result in serious damage, including painful eye and skin irritations.
⚠️ WARNING (California Proposition 65): This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
Q: What are the dimensions of the Ozone UV Germicidal Light Sanitizer?A: The dimensions are ten inches in length, seven inches in width, and three inches in height.
Q: What is the power and voltage of this UV lamp?A: The lamp operates at twenty-five watts and one hundred ten volts.
Q: What wavelengths does this lamp emit?A: It emits ultraviolet light at wavelengths of one hundred eighty-five nanometers and two hundred fifty-three point seven nanometers.
Q: How do I set the timer on this lamp?A: To set the timer, hold the desired time Delay button until the lamp blinks, indicating the timer is set.
Q: What is the recommended area for using this lamp?A: This lamp is suitable for areas up to four hundred square feet, such as living rooms, bedrooms, kitchens, and bathrooms.
Q: How do I pair the lamp with the remote control?A: Power up the lamp and then press and hold the On/Off button for at least three seconds to pair it.
Q: Is this lamp safe for use around pets and plants?A: No, this lamp should not be used around pets or plants, as they must leave the room during operation.
Q: How do I unpair the lamp from the remote?A: To unpair, press and hold the Delay fifteen-minute button for at least five seconds after powering the lamp.
Q: What safety precautions should I take when using this lamp?A: Avoid looking directly at the bulb, and ensure no humans, pets, or plants are in the room during use to prevent UV exposure.
Q: Can I use this lamp for illumination purposes?A: No, this lamp should not be used for illumination as exposure to ultraviolet light can cause serious harm.
Q: What materials is the lamp made from?A: The lamp is made of plastic, ensuring it is lightweight and easy to handle.
Q: How should I clean the lamp?A: To clean the lamp, wipe it gently with a soft cloth while avoiding touching the lamp tube directly.
Q: What should I do if the lamp arrives damaged?A: If the lamp arrives damaged, contact customer support immediately for a return or replacement.
Q: Is there a warranty on the lamp?A: Yes, this lamp typically comes with a warranty, but please check the product details for specific terms.
Q: How long can I safely run the lamp?A: You can set the timer for fifteen, thirty, or sixty minutes to ensure safe operation.
Q: What is the best way to store the lamp when not in use?A: Store the lamp in a cool, dry place away from direct sunlight to maintain its lifespan.