3 Way Touch Sensor Dimmer, Touch Lamp Repair Kit Control Module, Replacement Sensor, Touch Switch, 150Watt.

Have You Found Yourself Replacing Lamps Or Over Paying For A Simple Sensor Change?Do You Want To Save Time And Money?Then Youve Come To The Right Place!Esc Inc. Has Been In The Repair Industry For Over 30 Years!Well Guide You Through This Simple Process So That You Never Have To Replace Your Lamps Or Over Pay For A Sensor Change Again!-Just Follow Our Easy Wiring Diagram For Directions Color Wire By Color Wire!- Easy 4 Step Process To Installin Most Cases The Previous Touch Sensor Has Permanent Wire Nuts, Cut The Wires To Remove Them And Strip Back To The Raw Copper Wire (If They Are Removable Wire Nuts Twist Counter Clockwise To Remove, And The New Orange Wire Nuts Will Turn Clockwise For New Wire Connections) On Both The Wires From The Plug And The Wires From The Lamp. (Black And White On Instructions). 1. Refer To Wiring Diagram While Connecting Each Wire. If There Is An Existing Touch Wire In Some Cases It Is Easier To Cut And Strip The Wire From The Lamp So You Can Wire Nut To Join (Green) Touch Wire From Sensor Box. Use Your Own Judgement You Can Always Remove The Bolt From Lamp Base And Connect The Yellow Wire Metal Circle To The Touch Surface As Intended. (See Options 1 And 2 On Instructions) 2. Connecting (White) Using A Wire Nut Connect White Wire From Sensor Box To One Wire From The Lamp And One Wire From The Plug (3 Wire Connection 1 Lamp, 1 Plug, And 1 White). 3. Connecting (Red) Using A Wire Nut Connect Red Wire From Sensor Box To The Only Remaining Wire From Lamp. 4. Connecting (Black) Using A Wire Nut Connect The Black Wire From Sensor Box To The Only Remaining Wire From Power Plug. - Dont Forget Your Bragging Rights Here With Us, Or With Friends And Family!-Now Get Yours Before We Run Out Of Stock!Just Click